vertical door kit help
10-29-2009, 07:36 AM
#21
Vendor - Former Vendor
iTrader: (7)
Join Date: Oct 2009
Location: NJ
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
if u must do them...i had the verticaldoorsinc kit on my car...install is very easy and kit is good quality...also the door opens wide enough without lifting them up to get in and out...i never raised the door when i got in and out of the car...but like i said a year down the road u will get tired of them...your car tho so do what u like.
10-30-2009, 08:01 AM
#23
Registered User
Thread Starter
iTrader: (2)
Join Date: Sep 2009
Location: saddle brook nj
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
yes i get it dave there played out so u guys so. i jus like them thats all. dident wanna fight with yu guys i love this forum all i was doing is asking about quility of a kit. i ended up getting a used verticle doors inc
10-30-2009, 08:03 AM
#24
Registered User
Thread Starter
iTrader: (2)
Join Date: Sep 2009
Location: saddle brook nj
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
if u must do them...i had the verticaldoorsinc kit on my car...install is very easy and kit is good quality...also the door opens wide enough without lifting them up to get in and out...i never raised the door when i got in and out of the car...but like i said a year down the road u will get tired of them...your car tho so do what u like.
10-30-2009, 10:44 AM
#26
Vendor - Former Vendor
iTrader: (7)
Join Date: Oct 2009
Location: NJ
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
yes u need to either trim the inside of the fender or roll it...i trimmed mine...also u do not need to cut the wiring harness to make them longer...the kit says u do but u can just remove the door panel and cut some clips that hold the harness to give u a little extra play...i installed mine so if u need help PM me while u do it.
Thread
Thread Starter
Forum
Replies
Last Post
