Z badge question
#1
Registered User
Thread Starter
Join Date: Oct 2003
Location: HNL
Posts: 254
Likes: 0
Received 0 Likes
on
0 Posts
Z badge question
Just wondering if anyone has replaced their "Nissan" badge with the "Z" one from Courtesy Nissan.
How hard was the install? Is it removed by the heatgun/floss or does it have mounting posts behind the badge?
thanks
How hard was the install? Is it removed by the heatgun/floss or does it have mounting posts behind the badge?
thanks
#2
Registered User
iTrader: (5)
Join Date: May 2002
Location: Jacksonville, Florida
Posts: 2,006
Likes: 0
Received 0 Likes
on
0 Posts
Hard to get the stock one off......spent lots of time with the hair dryer. There are 3 "nipples" on the bumper which the badge "straddles." Move the hair dryer around and get the glue soft all the way around the badge before trying to get under it. A thin plastic scraper is the best idea for getting under it, and try to get under the middle bar of the Nissan burger first (as the Courtesy badge will cover any scratches you might make, if you're not careful enough).
Good luck and enjoy the new look!
Good luck and enjoy the new look!
#3
Registered User
Thread Starter
Join Date: Oct 2003
Location: HNL
Posts: 254
Likes: 0
Received 0 Likes
on
0 Posts
Thanks MSOsr
I was wondering if there were anything else behind the badge like a post or pin. Just ordered set but has not come in yet, and did not want to screw anything up. Good call on starting in the middle.
As long as there are no "clips" holding the posts behind the badge, I think I should be Ok.
I was wondering if there were anything else behind the badge like a post or pin. Just ordered set but has not come in yet, and did not want to screw anything up. Good call on starting in the middle.
As long as there are no "clips" holding the posts behind the badge, I think I should be Ok.
Last edited by wakaZ; 10-15-2003 at 11:03 AM.
Thread
Thread Starter
Forum
Replies
Last Post