Would anyone be interested in a new gauge mounting solution
#1
Registered User
Thread Starter
Join Date: Dec 2009
Location: Florida
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Would anyone be interested in a new gauge mounting solution
Im am working on a mounting solution for any extra gauges we may need in our z's (wideband, boost, etc). Here is what I have so far.
I have access to a CNC machine so I can make these in an instant. As you may notice in the picture the panel is a little short, but that was my fault on measurements lol. If I had enough interest I was thinking about selling them for $25. I could do a single gauge set up as shown, or I could do double. I can powder coat it in any color, and Im working on one where I could have the 350z logo lit up on the panel, but that is a work in progress. Mounting brackets and mounting instructions will be included. I could also have "350z" silk screened on the powder coated ones, anything is possible. If anyone is interested you can post, or pm me. Here are some more pictures:
Thanks,
Shawn
More pictures and updates will be later this week!
I have access to a CNC machine so I can make these in an instant. As you may notice in the picture the panel is a little short, but that was my fault on measurements lol. If I had enough interest I was thinking about selling them for $25. I could do a single gauge set up as shown, or I could do double. I can powder coat it in any color, and Im working on one where I could have the 350z logo lit up on the panel, but that is a work in progress. Mounting brackets and mounting instructions will be included. I could also have "350z" silk screened on the powder coated ones, anything is possible. If anyone is interested you can post, or pm me. Here are some more pictures:
Thanks,
Shawn
More pictures and updates will be later this week!
#2
Registered User
iTrader: (87)
Join Date: Dec 2006
Location: Lexington, KY
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
This is exactly what I need lol. I just have my AFR hanging in that spot right now. I don't need powdercoating or anything. If you have one available, let me know. I will send payment now lol.
#6
Registered User
Thread Starter
Join Date: Dec 2009
Location: Florida
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
This is exactly what I need lol. I just have my AFR hanging in that spot right now. I don't need powdercoating or anything. If you have one available, let me know. I will send payment now lol.
Couldn't you just do these in 1/8th ABS plastic?
Once I get the mounting solution all squared away, I will start a list of people who would like one of these.
Trending Topics
#8
New Member
iTrader: (8)
Join Date: Dec 2009
Location: North Jersey
Posts: 418
Likes: 0
Received 0 Likes
on
0 Posts
if u can make a piece thats angled from the front right corner to the rear left corner(so that the gauges are slanted towards the driver) i would be very interested. otherwise u can also just use 2 gauge pods. let me kno!
#13
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
I'm thinking of something like that but with 3 gauges, Air/fuel, oil temp and have room for vac later if i go boost.
Thread
Thread Starter
Forum
Replies
Last Post