hey everyone quick question, i bought my z with a nismo V1 Spoiler. the Spoiler is damaged. the "wing" part is loose on the base? not sure if u get what im saying. it might even be a replica not sure. anyhow i want to remove it and get a diffrent wing, after long and hard (giggity) thinking i dont really like the Nismo spoiler because i dont have the Aero kit. so i was wondering if any other spoilers on the market have the same bolt pattern. so i dont have to re-drill holes or fill holes.. or if someone wants to trade me hatches SOCAL

 

The authentic is two pieces (base, wing) but I'm not sure what bolts are used or how they connected to each other. I would just remove the spoiler and troubleshoot from there.

The holes won't line up with any other spoiler so you will need to trade hatches.

 

ya then its a replica....... time for super glue

 

I'm not sure that the replica isn't two pieces as well, it probably is but the only way to tell is to remove it.

 

i think it takes four screws to bolt it down, with 3m tape included. There is a diy or a thread where a member with a red z installs the wing and it shows the marks/bolts where it goes.

 

4 allen head bolts hold the wing to the base and 5 nuts then hold the base onto the hatch. Just remove the interior trim panel and start tightening for now.

 

The US version is 2 piece the JDM version is 1 piece and I suspect replicas were 1 piece. Bolt hole locations differ between them IIRC