I just picked up my 350z and the aftermarket tires do not have sensors in them. I hate the yellow light so just as I did in my tundra I decided to cover it up with electrical tape. Install went well until I plugged my gauge cluster back in. The tank was almost empty and now it reads 3/4 the way full and the temp is 3/4's the way up to hot. Those were the only 2 pins I removed. Obviously I screwed something up. Is there a special way to put the pins back on once removed? I just popped them off and pushed them back on towards the bottom. Please help.. My gas gauge is all out of wack!!

 

you physically removed the gauge needles?


my suggestion, fill the gas tank to full, and then let the car idle for 10-15 minutes.

then place the fuel needle to full and the temp needle to the middle. and hope for the best.

i have no idea why you would do such a thing for just a caution light.. now look at what you have done..

 

Dude my gas gauge is so screwy ha Its not that big of a deal. Just pay attention to how many miles you drive and you'll know when to fill up..

 

^ lol Chebosto i agree that light has been on for me for a while and I dont even mind it anymore. Just curious as how much a new cluster would be?