In the first picture is more or less how i want it. I know they have the parts that go on the back the lower the sides but they dont really wrap around. I want my back bumper to be lower but i still want my set up visable like in the bottom picture. Anyone know a bumper that lowers the sides with a gap in the middle?

 

i know that picture site is down the road from me

 

You could always buy that rear lip and have a body shop modify it. Do Luck also makes a bumper that might be more of what your looking for

http://vadwheels.com/Portals/0/LiveC..._Rear_Wing.jpg

 

cool i know where dat is

 

ings +1 with the center painted black will have a similar look

 

the ings bumper is more along the lines of what you're lookin for cause it sits low on the sides

 

Are those two guys in the pic holding hands??

 

I think this looks more like the vertex rear add on, shaved in the middle.

 

i think its a vertex too

 

+1 on ing bumper
Edit: BTW, that is not my car

 

I've seen a couple of members on here back in the days cut off the center part.

 

^ which rear add on?

 

On the Vertex rear half lip. I had considered doing this to mine but the stock bumper would show if it's just a cut.

 

that was some cool pictures

 

INGS bumper is pretty sweet. It'd be pure sex for me if it wasn't for that extended squarish part.

 

Is that a stock spoiler in the first picture? That makes it flow really well.

 

Ings +1 rear bumper. You don't have to cut the rear from my understanding. Just tuck it like you would with an OEM bumper.

 

Ings looks so good one of my favorite full rear bumpers

 

Is the Ings +1 urethane? I can't imagine frp or pfrp being tucked under like OEM.

 

doesnt look like it was cut out..probably painted black??