I've got a few on my SD card on my phone, but its been ****ed for a few weeks. I can post a few when I get home tonight since I dont have a microSD card reader on my work computer.

It was physically the same looking as the TK ****, finish may have been a little more polished looking, but not a mirrored finish, just due to the material used.

Overall I was trying to use a material with a lower thermal conductivity to prevent it from getting too hot in the summer. Needless to say, metal is metal, ***** going to get hot.

It was a good **** though, better than any I've used before. Sold it to one of the ohio guys on the cheap after I sold the 350.

 

 

Yep, took your advice. Just ordered a polished finisher from zeetoyz.

Also, Brrcats, you did a great job fabricating that.

 

Thanks bud, I thought it turned out pretty good myself.

 

New pic with the polished finisher from zeetoyz!

 

where can I get one of these?

 

Well this is gay... that first picture of the "Fatboy" in the review is a Photoshopped version of MY old TK shift ****.

Their version of the photo...



The original photo - taken by me. Notice how you can see the logo on top in this one.

 

wow that's terrible

 

Oh wow, that's horrible

 

 

Just FYI, TK **** is 1 lb 2.2 oz, or 515.6 grams.

 

^ How much do they weigh?

 

X2...

 

You know what's funny, if you aren't logged in to the board, the word "****" is censored... The thread looks ridiculous.

 

I installed my fatboy shift **** and the top of the shift lever hits the roof of the **** before it tightens. Fully threaded in, it's loose and spins freely. Besides Loctite, am I missing an insert or something?

 

I just installed mine today and it was a pain in the *** to get the stock one off..but once the **** was off there was a thick ring that sits around the threaded part of the shifter...I'm not sure if that has anything to do with your problem, but i left it there and my shift **** screwed on perfectly.