hi, i dont want to drill holes in my nismo v2, so i bought the show n go license plate holder. i was wondering how to mount it like on youtube without cutting the bumper

 

By looking at the parts,it appears that you will have to drill a few holes in your bumper to install this unit.Does look like a big deal.The holes needed are probably under the
lip of the grille opening out of sight.

 

i have the show n go on my v2, and they just screwed the sliding bar on the horizontal support to keep things tight and straight (not a big deal). installing such piece doesnt require anything, but only some creativity and some tools.

http://www.youtube.com/watch?v=Z15xo...1&feature=plcp

 

It's not very complicated at all, everyone uses the center support

 

Anyone see these installed on the v3/ oem nismo bumpers?

 

The only way is under the front lip. Only if u didn't drop or u might rip it off. My friend cut part of his bottom diffuser to raise it a little.

 

+1 this will be useless on a V3 if it's slammed

 

Ya I figured it would be useless on a v3 and thought the only way to do it was under the front lip and probably preferably in the middle.