DIY request: how/best way to trim down 350z interior metals for track car
Thread Starter
Registered User
Joined: Jun 2012
Posts: 86
Likes: 0
From: Murica
DIY request: how/best way to trim down 350z interior metals for track car
hey guys,
did a quick look around and i cant find any info on this. whats the best way to cut down and remove the metal area under the plastics that house the rear speakers (behind our seats), and rear strut bar. im including a pic of what im talking about and someone that has done a clean removal for an example
did a quick look around and i cant find any info on this. whats the best way to cut down and remove the metal area under the plastics that house the rear speakers (behind our seats), and rear strut bar. im including a pic of what im talking about and someone that has done a clean removal for an example
Joined: Feb 2008
Posts: 13,406
Likes: 130
From: MexiCali dodging potholes
- a good drill and drill bits to drill out the spot welds
- a dremel saw max
- reciprocating saw
All good ways of going about it....no matter what you use plan on a good 3-4 hours of noise
- a dremel saw max
- reciprocating saw
All good ways of going about it....no matter what you use plan on a good 3-4 hours of noise
Thread Starter
Registered User
Joined: Jun 2012
Posts: 86
Likes: 0
From: Murica
Thread Starter
Registered User
Joined: Jun 2012
Posts: 86
Likes: 0
From: Murica
sweet documentation there. thank u so much for that link man!!
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
Jun 19, 2022 06:30 PM
350Z Project X
Maintenance & Repair
11
Oct 17, 2015 05:16 PM