I was told the fenders will fit with OEM bumpers or there standard kit. Should be a few months before they arrive... ~25mm wider front and ~30mm wider rear.

the hoods are now in stock also.

 

Does anyone know if the rear fender is just an add-on or if you have to replace the entire quarter panel on the car?
If you have to replace the entire quarter panel, that is some serious cash to get it installed. Those things are welded onto the frame.

 

SWEET! THANKS

 

The pix look interesting. The fender don't seem to be wider than stock. Unless this is different bumper. I'll find out what kind of offset they are running on the front wheels.

 

The fenders look weird because they are only 25mm wider and that is only at the very top of the wheels... they are same width as stock where they meet the bumper and sideskirt (kind of curved out at the top)

If I remember correctly the car was running pretty conservative wheel sizing, something like 18x9 et 12 front and 18x10 et -4 rear... it can definetly fit wider and lower offset wheels.

 

That's some serious offsts.

 

I would run something more aggressive around:

18x9.5 et +2 front and 18x10.5 et -12 rear

or 18x11 et -4 rear if running other than Do-Luck wheel since they only go up to 10.5" wide)