Ultimate Emanage A/F Target Map
#1
Registered User
Thread Starter
Join Date: Oct 2005
Location: St. Louis
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Hello all! This is my first post. I do not drive a 350z but I have been lurking in your forum for long enough that it was time to register.
I have an UEM on my comptech s/c s2000. I have an AEM Uego connected into it and I think I would like to play with the A/F target map. I see there are quite a few of you with the UEM and I was wondering if anyone has had any luck with it? Greddy told me corrections must be made when using the AEM due to it's non-linear output. Anyone tried it?
I have an UEM on my comptech s/c s2000. I have an AEM Uego connected into it and I think I would like to play with the A/F target map. I see there are quite a few of you with the UEM and I was wondering if anyone has had any luck with it? Greddy told me corrections must be made when using the AEM due to it's non-linear output. Anyone tried it?
#3
Registered User
Thread Starter
Join Date: Oct 2005
Location: St. Louis
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://my350z.com/forum/images/icons/icon1.gif)
From my conversations with greddy, I understand that the AEM is very accurate from 10-12.5 but slowly kreeps off after that. I have tested mine against the one on a dynojet and it was dead on. Anyone tried the map with any other wideband?
Thread
Thread Starter
Forum
Replies
Last Post