2003 350z ECU pinout
#1
2003 350z ECU pinout
I made an easy to read diagram last night for the ECU pinout. I gotta go thru and looked up pins I dont already have, these are just the ones from the engine control section of the service manual.
if you have a service manual for 2004, 2005, 2006 in PDF format let me know so I can add those.
hopefully should help someone... i always had these around for other cars that i worked on at the shop and it made my life a little easier to have a website i could always just go to and have a ECU pinout there when i need it.
i am getting close to time to start changing around a few things with my FCON to get the cruise control working again and have the FCON automatically control the stock ECUs "anti brake torque" function. thats why i was puting this together to begin with... and figured it may help someone else at some point.
http://www.cj-motorsports.com/products/350ztech1.htm
if you have a service manual for 2004, 2005, 2006 in PDF format let me know so I can add those.
hopefully should help someone... i always had these around for other cars that i worked on at the shop and it made my life a little easier to have a website i could always just go to and have a ECU pinout there when i need it.
i am getting close to time to start changing around a few things with my FCON to get the cruise control working again and have the FCON automatically control the stock ECUs "anti brake torque" function. thats why i was puting this together to begin with... and figured it may help someone else at some point.
http://www.cj-motorsports.com/products/350ztech1.htm
Trending Topics
#8
we are finalizing the casting. we were going to CNC the bottom half and hand fab the upper, but it is too time consuming and we would never be able to keep up. The CNC bottom part machined off 40lbs of aluminum from the billet... it takes way too long on the CNC.
It will be a few weeks before I have much to say about it now... it was about ready to release but now we gotta wait for the casting.
It will be a few weeks before I have much to say about it now... it was about ready to release but now we gotta wait for the casting.
Thread
Thread Starter
Forum
Replies
Last Post