To all Procharger owners, I have searched for hours, called ATI, done extensive reading...... No found answer.. No threads on this subject!! Im sure it would benefit many procharger owners when it comes time to replace their filter...........

Thanks in advance.. 1st Thread ever.. I dont post B.S.
__________________

 

http://www.procharger.com/pdf/appGuide.pdf

On Page 21, I knew ATI was telling me the wrong info.. He told me (ATI Tech)the outlet hose diameter info which was 2.5"as he said. But, its the inlet hose diameter(Intake) which was 3.5"(I was right) so for anyone wanting to replace their intake filter for the Procharger.. now we know.. Intake outlet is 3.5"

 

Couldnt you just have gone outside and measured it?

Edit: Forgot not as much room on 350z.

 

No, not at all (Because of the intake positioning) If you read my first statement, I would have to go outside slowly start pulling off the bumper alone (major PITA) then get a tape measure pull it around the intake. Then pull the bumper back on. 2 hours of work at the minimum just to measure it.. Not worth the hassle if i can find online..

REMEMBER THIS IS A PROCHARGER AIR INTAKE FILTER.. not a ram air intake, which takes two seconds..

 

Are you talking about the filter canister or the intake on the procharger unit?

 

Yes, talking about the canister.... Just giving out the info for anyone who has a procharger and would like to replace their filter..

 

Time for some twins!

 

Damn bro.. You bumped a 5 yr old thread.. The intake dimension was 3.5 in FYI for procharger owners.. RE1920 k&n filter..