upgrade for a Vortech SC
Thread Starter
Registered User
iTrader: (6)
Joined: Nov 2003
Posts: 10,500
Likes: 2
From: council bluffs Ia.
Hey guys...I have a T-trim blower for sale . If you had been thinking of upgrading your blower . You could get it a little cheaper . Just sell your SQ trim after you buy mine . Vortech wants about $1100 for a trade in to a T-trim . If you bought mine for $1700 and then sold yours for [ say $1000 ] you get thte upgrade for quite a bit less . And will not have to wait for up to 6 weeks [ like I did ] to get your blower back from Vortech . Vortech wants $2700 for a new T-trim blower...mine has less than 2000 miles on it .
I aslo have the bracket and 2 smaller pulleys for sale
I aslo have the bracket and 2 smaller pulleys for sale
Last edited by booger; Jan 21, 2007 at 03:13 PM.
probably all of those things
though I think someone could run a T-trim with a 3.33 pulley fairly ok if they had the proper supporting mods for a stock block. I think it'd probably be a little more aggressive power than the stock blower with a 2.87 pulley
though I think someone could run a T-trim with a 3.33 pulley fairly ok if they had the proper supporting mods for a stock block. I think it'd probably be a little more aggressive power than the stock blower with a 2.87 pulley
Last edited by sentry65; Jan 21, 2007 at 10:05 PM.
Thread Starter
Registered User
iTrader: (6)
Joined: Nov 2003
Posts: 10,500
Likes: 2
From: council bluffs Ia.
Sentry is about right . I dont have a log in front of me . but I'm at 4psi as soon as the bov closes...13psi @ 5900rpm...this is with the 3.12 pulley . The T-trim will make more boost and flow more air . The small amount of time I did have on the 2.87 and stock blower . I can say the T-trim has quite abit more bunch down low . Im going off my wheel spinning ability with my AT5
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
Oct 29, 2020 07:44 PM




