I finally got around to dropping my car off to get it tuned. All in all I am happy. A little minor hickups but $hit happens. Anyways check out the dyno sheets and tell me what you guys think.

Map
1 Tuned 93 Octane (7100 rev limit, no speed limit, idle @900)
2 Daily Driver (Stock ETC, rev@ 6300)
3 Valet (Stock ETC, 3500 rev, 50mph)


The map switching is so easy. Just have to push the cruise control button to choose a map. The car pulls a hell of a lot better as you can see.

Here is the dyno with everything stock and just the turbonetics kit(no other mods)




And here are the updated #'s. They dynoed the car with the Turbonetics reflash with my exhaust and plenum spacer. Then you can see UpRevs tune.




Now all I need are 18's and DR's in the rear and Ill be set. Summer here I come!!

 

Nice numbers!!

 

ooooh nice.

 

I like the valet idea.

 

Bout time you got it tuned. Congrats, decent #'s.

 

Nice numbers. Car must be pretty fun. Careful with that 7100 rpm reving. It is pretty fun Im sure, but your stock motor probably wont be very happy with it after a while.

 

+1, only use it when its necessary to get in someone's as$....lol. nice numbers.

 

Busting somebody's a$$ is not worth blowing your motor over. Trust me keep the rev limit stock or you will be sorry...btw those are some of the lowest TQ #'s I have seen from a TN kit, how much boost are you running? edit-n/m TQ is good now that baseline was def on the low side. COngrats on the tune.

 

man that TQ falls flat on its face after 5500 rpms

 

congrats on the tune. Are you using the reflash?

 

i believe the blue line is the reflash that came with the TN Kit.. the red is UpRev's flash

https://my350z.com/forum/showthread....ighlight=Uprev

 

Blue is turbonetics reflash with the mods. Red is uprevs tune. I torque is low but the car drives a hell of a lot better then with the turbonetics flash.

 

by looking at the dyno.. its a whole lt smoother.. which improved your response and driveability

 

well thats pretty awesome. Congrats again.

Thanks Doug for the link

 

.. those are good #'s

 

You go Phil! When we gonna run? haha.

 

Hey I live in New Braunfels whats henderson performance?

 

Very nice Phil, Congrats. Im starting the vortech install tomorrow, were going to need to run one of these days.

 

They normally build high HP corvettes and vipers. I havent been in contact with them in a while but I think they moved to a newer location. They didnt tune my car. I just took it there to dyno after I installed the kit with the turbonetics flash.

 

Thanks man,Ill be ready for ya.