Just wondering if any of you guys with more experience with FI could give me an idea of what kind of gains I might be looking at with my current setup if I were to throw an mrev2 lower intake into the mix?

 

Not a whole lot you have the same lower plenum now, the new one would be machined slightly. Just run a spacer IMO...

 

I think the MREV2 is geared more towards the revup motors.

 

Yeah I know its geared more towards the rev up but It still gives gains on an NA motor although they are minimal i was just hoping that i might be able to get ten hp or so out of this on an fi application

 

My input will probably not be of much help, but I had an MREV2 and 5/16" spacer installed 8 months before going FI. I felt a difference with the combo, and it was a good experience taking apart the intake manifold to put it in there.

I can't tell you what differences an MREV2 and Spacer will have on your car, since I had the Motordyne stuff before the turbo. But being that we both have 5AT STS turbo setups, I'm guessing this input comes is not going to come from anyone with a more identical setup to yours.

 

Buy it and post #'s.. That would be nice..