What size injectors is needed to safely run a 100 wet shot on a vortech making around 410 whp on a mildly built bottom end w/ supporting mods?

 

"its a WET shot"

so it takes feul b4 the injectors so whats important is that your feul pump can handle it.

440cc is all you need for a vortech around 400rwhp

 

you will need a fuel return system... im guessing, b/c ur already leaning out on the vortech with 400rwhp in the top end

 

I don't have a return line and my car is fine I'm running 650CC injecters with around 100 shot


I think so far I'm the only one on here running nitrous and a Vortech

 

If it were me. I'd say, I'd need to run a return fuel system and go ahead and get some 650cc injectors.

 

i will be joining you soon

 

My ultimate goal is to run a 100 shot off of the vortech so I'd rather get the parts I need now instead of further upgrading in the future. This spring, I plan on installing the vortech tuner's kit along with 650cc, utec, 3.12 pulley, and walboro. Hopefully with a reflash and a good tune with supporting mods, I'll be at around 400 whp. By next winter, I'll probably have over 100k on the motor, which is when I'll build the bottom end for the 100 shot. Why aren't there more vortech and nitrous setups?

 

don't get 440s. The supercharger needs more injector than the standard 1cc per hp. I maxed my 440s out at 375 HP.

 

650cc get them

 

i states 440 to be minimum... i would defenetly get 650cc dow.

also you could be maxing out b/c of your fuel delivery system too.

 

Thanks for all the replies. I will go with the 650cc