I'm done with this $hit..
#121
New Member
Tell that to the guy who just offered me $4000 for:
1-GTM HR 350Z TT STG2
2-GTM SPEC 3" downpipes
3-Haltech haltech platinum 350z pnp EMS with IP Wiring Harness 4-Modification for HR (HR plug and play)
5-IP Boost Control Kit
6-AEM Wideband Uego Controller
7-DSD SLM II Boost, Oil Temp, Oil Pressure and EGT Gauges 60mm
8-GTM full return fuel system for HR
9-HKS Denso 1000cc Peak and Hold Injectors
10-IntensePower A-Pillar Triple Gauge Pod
1-GTM HR 350Z TT STG2
2-GTM SPEC 3" downpipes
3-Haltech haltech platinum 350z pnp EMS with IP Wiring Harness 4-Modification for HR (HR plug and play)
5-IP Boost Control Kit
6-AEM Wideband Uego Controller
7-DSD SLM II Boost, Oil Temp, Oil Pressure and EGT Gauges 60mm
8-GTM full return fuel system for HR
9-HKS Denso 1000cc Peak and Hold Injectors
10-IntensePower A-Pillar Triple Gauge Pod
#122
Registered User
Join Date: May 2010
Location: saudi arabia
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
thats really bad broo.....i dont know what the matter with the vq ??
you realy convinced me to stay running on stock motor cuz i realy dont have alot of money to lose with no results with the vq....good luck
by the way im wesam i called you to ask about you vq short block ^_*
you realy convinced me to stay running on stock motor cuz i realy dont have alot of money to lose with no results with the vq....good luck
by the way im wesam i called you to ask about you vq short block ^_*
#127
New Member
iTrader: (8)
Join Date: Jan 2007
Location: terre haute, IN; STL, MO
Posts: 6,457
Likes: 0
Received 7 Likes
on
6 Posts
i feel your pain. I'm done with mine. I will say this: don't blame the 350z or the vq block. It's not the engine's fault when someone tears into it and modifies it. No matter what engine platform you work on when you start modifying it the factor for something to fail goes up.
I had the bolt hole for a head stud on my block pull out after refreshing my internals. Apparently there is magic bolt size that is imposible to find a helicoil for so i'm up a creek. This car has been down since january. I'm so sick of having a modified car. The **** has seriously outweighed my fun so i'm probably going to get it out of my garage and get a decent fun car in it's stock form: nsx, porsche, tt supra. Something like that which is fun and i do'nt have to screw with it to have fun in it.
i completely feel your depression.
I had the bolt hole for a head stud on my block pull out after refreshing my internals. Apparently there is magic bolt size that is imposible to find a helicoil for so i'm up a creek. This car has been down since january. I'm so sick of having a modified car. The **** has seriously outweighed my fun so i'm probably going to get it out of my garage and get a decent fun car in it's stock form: nsx, porsche, tt supra. Something like that which is fun and i do'nt have to screw with it to have fun in it.
i completely feel your depression.
#130
New Member
iTrader: (8)
Join Date: Jan 2007
Location: terre haute, IN; STL, MO
Posts: 6,457
Likes: 0
Received 7 Likes
on
6 Posts
i worked for about 6 years building engines for a MX race team. 2 boys, same bikes. It seemed like no matter what i did michael's bike would always have problems and chris's bike ran like a champ with no issues. I used the same parts and same techniques and tuning on both. It was just random chance with some things on michael's bike that had nothing to do with the fact that it was a kawasaki because chris rode the same exact bike.
Don't get discouraged just because it's the same car that had problems before. Each build is different in itself.
#134
Registered User
iTrader: (1)
Join Date: Sep 2007
Location: Texas, Arizona,Cayman Island
Posts: 5,256
Likes: 0
Received 0 Likes
on
0 Posts
If it were me and funds were not ready available...I would park the car and save up. I am a nice guy...but to give things away for the prices listed above...that would make me a dumbazz nice guy
I see the VQ taking a few jabs lately...I don't agree with any of them...If its done right it will run right. Call it luck (and I am not the only one) but I had no issues with build one or two. I know the least of anyone on here about the VQ's...but I take what I know from other platforms and apply it here.
If my motor fails within a certain time limit...its the builders fault...its that simple...no discussion.
IMO...Get a builder that can AFFORD to stand behind their work....the last thing you want to hear from a shop when they F up your car is that they have $$$ issues.
Best of luck my friend.
#135
Cranky FI Owner
iTrader: (14)
Dont go back to stock, dont sell it.
Like XKR said, sit on it awhile if its possible for you.
I have too much going on personally and at work to think of fixing my Z, so its sitting and will be sitting a long time. Havent seen it in months and has literally 2miles driven since December.
All this time away from it makes me miss it a lot but most times its out of sight, out of mind!
Good thing is Im filling up the patience tank for when I get back to it again lol!
Like XKR said, sit on it awhile if its possible for you.
I have too much going on personally and at work to think of fixing my Z, so its sitting and will be sitting a long time. Havent seen it in months and has literally 2miles driven since December.
All this time away from it makes me miss it a lot but most times its out of sight, out of mind!
Good thing is Im filling up the patience tank for when I get back to it again lol!
#136
reading those posts; and am thinking to keep my Z below 500 whp mark!
reducing whp might be a good option to consider? as failure rate will be reduced as well.
any possibility for an engine swap? a v8 or tt 2jz? Emirates are near by
reducing whp might be a good option to consider? as failure rate will be reduced as well.
any possibility for an engine swap? a v8 or tt 2jz? Emirates are near by
#137
Registered User
I opted to sell mine but it was a working car....and I basically got a cash offer, sight-unseen......
parting out is a PITA.....
If mine would have popped I have no idea what I would have done, its hard to say until you are in that spot....like you said, its a tough pill to swallow to drop lots of $$ and have nothing to show for it.
I do have to say though, I miss it less and less every time I go to the pump!!!! <10mpg would not be fun right now in Chicago.
tom
parting out is a PITA.....
If mine would have popped I have no idea what I would have done, its hard to say until you are in that spot....like you said, its a tough pill to swallow to drop lots of $$ and have nothing to show for it.
I do have to say though, I miss it less and less every time I go to the pump!!!! <10mpg would not be fun right now in Chicago.
tom
Dont go back to stock, dont sell it.
Like XKR said, sit on it awhile if its possible for you.
I have too much going on personally and at work to think of fixing my Z, so its sitting and will be sitting a long time. Havent seen it in months and has literally 2miles driven since December.
All this time away from it makes me miss it a lot but most times its out of sight, out of mind!
Good thing is Im filling up the patience tank for when I get back to it again lol!
Like XKR said, sit on it awhile if its possible for you.
I have too much going on personally and at work to think of fixing my Z, so its sitting and will be sitting a long time. Havent seen it in months and has literally 2miles driven since December.
All this time away from it makes me miss it a lot but most times its out of sight, out of mind!
Good thing is Im filling up the patience tank for when I get back to it again lol!
#138
It would drive me crazy also if i hear you gave it away for that cheap
If it were me and funds were not ready available...I would park the car and save up. I am a nice guy...but to give things away for the prices listed above...that would make me a dumbazz nice guy
I see the VQ taking a few jabs lately...I don't agree with any of them...If its done right it will run right. Call it luck (and I am not the only one) but I had no issues with build one or two. I know the least of anyone on here about the VQ's...but I take what I know from other platforms and apply it here.
If my motor fails within a certain time limit...its the builders fault...its that simple...no discussion.
IMO...Get a builder that can AFFORD to stand behind their work....the last thing you want to hear from a shop when they F up your car is that they have $$$ issues.
Best of luck my friend.
If it were me and funds were not ready available...I would park the car and save up. I am a nice guy...but to give things away for the prices listed above...that would make me a dumbazz nice guy
I see the VQ taking a few jabs lately...I don't agree with any of them...If its done right it will run right. Call it luck (and I am not the only one) but I had no issues with build one or two. I know the least of anyone on here about the VQ's...but I take what I know from other platforms and apply it here.
If my motor fails within a certain time limit...its the builders fault...its that simple...no discussion.
IMO...Get a builder that can AFFORD to stand behind their work....the last thing you want to hear from a shop when they F up your car is that they have $$$ issues.
Best of luck my friend.
Because I don't live in the U.S, its hard for me to get engine builders to stand behind their work. They will come up with a million excuses to not to.
Hell, my GTM TT kit's BOTH exhaust manifolds broke on me after a regular car wash and I couldn't make GTM to send me replacements, they quoted me new ones price
Last edited by midz350; 07-18-2011 at 10:59 AM.