Anyone know the proper TQ specs for ARP L19 head studs and ARP Mains both with Stock girdle and say IP Billet Girdle?

I seen a few shops say 95 ft lbs on the L19's and 65ft lb on the mains

but does anyone know if the ARP Main TQ changes when using a
aftermarket girdle


http://arpinstructions.com/instructions/202-5801.pdf

 

Still need a answer so bumping this up

 

60 on mains with or without girdle.

 

^ Thanks Hal

Just wanted to make sure the aftermarket girdle was not putting extra pressure on the mains
which would affect main bearing clearance