Quick question/ odd request. My buddy is running a Utec for his supercharged Z and the map sensor pins have been pulled out for the Map sensor

Soooo, I have to solder the wires directly to the utec board, where the connector was, and primarily the red, green and black in terms of their placement, and I don't know where these primary wires get soldered onto.

If you were looking at the pin out from the back of the utec as if the connector were still there, where would each one of those wires get connected? red upper left? green lower right? black upper right?

Thanks in advance guys and appreciate any help anyone can provide.

 

Or if someone can take a pic of just the MAP connector that goes in the back of the Utec, I can figure it out from there.

 

I thought you guys could just use UpRev? Why the need for a UTEC?

 

Because my buddy already has the Utec, and we can adjust everything we need to ourselves without paying for an Uprev license... There are still a tremendous number of Utec ECU cars out there without any issues.

Uprev is nice stuff, but this didn't cost us a thing, and we can do it all ourselves.

I think I figured out how to get it all matched correctly anyway.

 

Utec was flawless on my vortech setup.

dont have any pics of the map though, hope you can get it figured out!

 

Actually just figured out how to touch the wires to the board and figure out what gives me the correct readings... Much more relieved, and after I will write myself a diagram in case anyone ever needs it in the future.