Found leaves in my stock intake!
I opened my airbox the other day and found this, OMG, 
BTW, I have been using K&N filters for over 10 years now, and not one problem, EVA! The key is too not over oil and let it dry for 24 hours!
BTW, I have been using K&N filters for over 10 years now, and not one problem, EVA! The key is too not over oil and let it dry for 24 hours!
Last edited by zand02max; Apr 11, 2005 at 11:57 AM.
See if you can make the Apexi power intake fit....its an oiless paper filter...
http://www.apexi-usa.com/intake_powerintake.asp
http://www.apexi-usa.com/intake_powerintake.asp
VinUnleaded,
Now you see why I built my own CAI
My picture of it in the other thread does work...
I agree, if Oiled properly, you will not have a problem with the MAF. It's not a dipping process... spray/dry and go. I looked at the BLITZ or all wire mesh filter and I can't quite remember what it was, but I think it didn't clean as affectively as the oiled cotton filters. Don't quote me on that though, there was a reason why I didn't go that route and it wasn't $.
You seem to look for good deals. Go with the JWT pop charger and make your own heat shield.
Or if you want to be really cheap...go to ebay, pickup the essentials for a short ram intake, like same conical filter, aluminum pipping, and small aluminum collar/bracket with the four screws right before the MAF sensor. There are package deals out there that offer the two necessary parts..ie conical filter and collor/bracket that attaches where the oem box detaches right before the sensor.
http://cgi.ebay.com/ebaymotors/ws/eB...category=38634
Now you see why I built my own CAI
My picture of it in the other thread does work... I agree, if Oiled properly, you will not have a problem with the MAF. It's not a dipping process... spray/dry and go. I looked at the BLITZ or all wire mesh filter and I can't quite remember what it was, but I think it didn't clean as affectively as the oiled cotton filters. Don't quote me on that though, there was a reason why I didn't go that route and it wasn't $.
You seem to look for good deals. Go with the JWT pop charger and make your own heat shield.
Or if you want to be really cheap...go to ebay, pickup the essentials for a short ram intake, like same conical filter, aluminum pipping, and small aluminum collar/bracket with the four screws right before the MAF sensor. There are package deals out there that offer the two necessary parts..ie conical filter and collor/bracket that attaches where the oem box detaches right before the sensor.
http://cgi.ebay.com/ebaymotors/ws/eB...category=38634
Last edited by Zquicksilver; Apr 11, 2005 at 02:04 PM.
vinunleaded,
ztube is much better than the stock G35 intake tube....however I thought the Z's came with them already....our stock G tube is different and more resitrictive...
ztube is much better than the stock G35 intake tube....however I thought the Z's came with them already....our stock G tube is different and more resitrictive...
Thread
Thread Starter
Forum
Replies
Last Post
