Yesterday i got a great deal on a skunk2 plenum so i couldnt pass it up. I have an 06 350z and this is my first mod to the car. My question is do u think this a decent mod for the rev up engine or is it only good for the older vq35? it was only $150. I didnt dyno or anything, but i raced my roomates 2005 g35 and beat him from a roll and a stop, previously he would barely win. He has intake and exhaust on his car. Will i see an even bigger gain from the spacer when i get my popcharger and injen TD exhaust?

 

...

 

where did you get it? I have an 03 would it work with mine too. Sounds like a great mod.

 

Im sure you could find it off there website. My friend sold me his cheap, he didnt want it, cuz hes going FI and nvr installed it.

 

Did yours come with a little plastic L-shaped hose connector? Mine came with one and I have no clue what it is for.

 

i honestly thought that the newer rev-up motors didnt benefit as much from a spacer as did the older cars. i thought that if you used an older lower plenum that would yield higher gains. i will find the link for you!

 

heres one...

https://my350z.com/forum/intake-exhaust/172203-motordyne-5-16-spacer-loss-of-power.html

i know its long but basically read the first couple of pages!

 

here's the other. the first page is very informative, but mainly read post #18!

https://my350z.com/forum/intake-exhaust/169741-review-rev-up-plenum-installed-on-287hp-motor.html

 

L shaped is for the coolant hoses that run through your throttle body to help warm up motor...bracket is to lower intake temps from removing hot coolant from throttle body

 

Would also like to know if you would continue to gain from the spacer from other mods. i have read up on alot of other threads but cannot seem to find an answer.