Man I hope it yeild good numbers. The finish looks great. So many plenum to pick from

 

did this thing die?

 

bump..again

 

i am exhausted waiting ...

 

Bump

 

Tag

 

Doug is having a new butterfly for the TB made. The first one was not large enough. I was throwing all kinds of codes and going into limp mode after one good pull. It makes it very hard to test.

Remember this is a completely brand new cnc'ed throttle body these setbacks will happen.

 

thank you for the update. good luck, i cant wait to see how it turns out! this strikes me as the kind of thing that would make more gains if you took it to technosquare and they flashed your ecu for it. what are your thoughts?

 

another intresting thought is....many of us have a the MD spacer, what will happen if we added this new big mouth penlum and new throttle body? Anyone from crawford wanna take a bite at it?

 

I don't understand the point of adding the spacer to the Crawford or Aps for that matter. As much R/D goes into it, I'm sure if it made any gains for their plemium they would just build it taller. I could be wrong though, just a guess.

 

2 week bump

 

this thing died... too bad they didnt tell us....

 

things take time. give them time.

 

no news on this thing yet? it better be good!

 

 

 

It hadn't died yet we have just been to damn busy in the shop to do anything . The end of Aug usually gets a little slower and I'm hoping to try it again in the next week or so to see if we can get the thing calibrated right and go to the dyno.

 

The eng will get a lot more air, but the spacer will not work with the plenum it would be too tall.

 

What will be the aproximate cost of this plenum when it comes out......

Mainly, can I afford this one or just get the $200 one.

 

Maybe I missed it, but any idea of cost yet?