bigzimmy

Ok so quick back story. I was driving to work and must have run over a squirrel or rabbit or something, because when I looked under my car I saw blood, hair, and the wires to my driverside Oxygen sensor comming off the catalytic converter torn out of the connector.

My problem is that I don't know what the color wires go where and haven't been able to find anything online no matter how hard I search. I've tried chiltons, the nissan repair manual, basically everything. I was hoping that someone couldn't maybe take a look under their Z and see which color wires go where on the green female connector for the drvers side. Any help would be so greatly appreciated. I can't stand the cel light anymore.

Thanks
Brian.

crg914

iTrader: (5)

Is there a pigtail on the connector or did the wires come completely out leaving nothing to solder to?

Most likely they will be the same arrangement as the O2 sensor on the other bank. There will be two grounds, so those can be interchanged. One will be signal, and one will be O2 heater.

Trying to reset the wires in the connector may not be worth the hassle though. NAPA has it listed for $72.99.

Good luck.

bigzimmy

The wires and connector came out un-harmed I just need to plug them back into their respective hole. I've priced ones at pepboys, autozone ect ect but for the prices your talking about they are the universal kind that come with no connector so I'd be in the same boat.

Thanks for the suggestions, much appreciated.

crg914

iTrader: (5)

I will try to remember and get on All-Data tomorrow and pull up connector end view for the 02 sensor. What year is your Z?

bigzimmy

it's an 03. Thanks a lot man