Almost got my Borla on and would like to know the torque specs for mounting up to the cats. The Accuseals are 30-32 foot lbs but no mention of the flange bolts.
If anyone knows please post......I'll be back in to check after install.

Install tip: Use a pry bar to get the stock exhaust off the rubber mounts, worked like a charm. So far extremly low frustration factor with the Borla true dual install, had more trouble with the Injen CAI.

O by the way; did everone re-use the stock exhaust flange seals?


CS track
Injen; polished
ground kit
Borla Dual

 

The nice guy i had install mine at Meineke he did an excellent job.
He was laughing when I told him about the torques recommendation of 35 lbs. he laughed and said well these are a bit more than that as he wailed on them. He did reuse the gaskets because I did not come with new ones and he said that the metal ones are fine. I had a push my exhaust in all the way I don't like the tip sticking out too far.

 

The flanges by the cats are 34-44 ft. lbs. according to the manual.

 

Thank you