Just wondering if i could put this muffler on the Z where the stock one is. I can weld and cut and all that, but i'm just wondering if the muffler would work right, given that there are two 2.5" inlets on one side and one 3" on the other. So i would have to put the 3" running pipe from the resonator to one side, and both tips will come from the other side, but one will have to run on the side of the muffler to go out the factory bumper cutout.

http://www.verociousmotorsports.com/...-Center-Outlet

 

No I dont think it will work the way its layed out. Magnaflow and flowmaster have a muffler that will work, tho I dont encourage it.

Just throw down a couple more hundred and get a used catback.

 

Too much work for what it's worth. What are you wanting to improve?