good question, surprised no one answered it.

 

actually no i didnt loose power. I made 235whp on a mustand dyno and 200wtq with test pipes, upper plenum, jwt popcharger, and my old borla exhuast. just had it dynoed again with the same mods except i had the motordyne exhaust. i made 249WHP and 204wtq on the same dyno.. hopefully that should answer your question

 

No loss of low end trq whatsoever. The XYZ's design along with the exhaust's 2.5" -> 3" piping allows easy breathing for the car providing low end trq as well as high end giving you efficient power gains through all the rpm's.

 

thanks... the question was actually focused on LOW END torque and power... see you might not have lost max power across the whole power band, but lost power or torque at the lower gears and rpms... your dyno sheet/graph would show all of this...

 

No I dont' think I lost any low end torque or power in the lower rpms and lower gears but I'll take a look again at the dyno sheets when I get done with class. If you were to loose any, you wouldn't feel a noticeable difference

 

Will the true dual be quieter or louder? more power out of the TDX??

 

Its a little louder, deeper and FI ready.

 

Rob, did you say there was no increase in HP? Over stock or over the HKS? Sounds pretty amazing!

 

Well I went from the HKS to the motordyne and there was really no difference. But over stock there is a difference for sure.

Keep a look out for my next video, I am getting some berk hfc's put on and a osiris tune on the 22nd.

 

^^ finally it's about time.

 

Yeah yeah.... Since you mention "about time" where is that Hi Res version that you were suppose to post up about 3 weeks ago...lol

 

lol

 

never had a chance. my friend shipped out to naples, italy for 2 years.. now if you would like to provide one then i will be more then happy to make one lol and the video would have to be editted by you so it would get done the right way lol

 

why did you decide to go with the berks (2.35" i think?) over a 2.5" hfc, like the fast intentions cats? im pretty sure berk dont have a 2.5" cat out (yet)....

 

I honestly don't know, besides the price difference, I didn't really look into size.

 

i would consider the 2.5" since that is the inlet diameter of your XYZ..

 

Well after getting them in, I decided to measure them. Looks good enough to me. I think I read that berk has redesigned them to 2.5.

 

looks good.. what time on friday are you heading over to Hp Logic?

 

Around 10

 

perfect!! yeah i knew berk were designing the 2.5" but didnt know they were out already... cant wait to see/hear vids when you get it on!