Vid of my new custom exhaust and highflow cats.
(my buddy started the video a little late and on the return run was too far down the road to capture a WOT as I went by, but you'll get an idea of how it sounds)
Will post a new one once the headers are in next week

http://www.imaginetstudio.com/350z/1st.wmv

 

what headers are you getting crawfords?

 

Chu got dat right...same time as they put the Crawford plenum in...next week

Wrong forum I know, but I had my Nismo S-Tune Suspension installed today...that with the Cusco Sways I installed earlier this week and she's dialed in tight

 

Sounds good. Very mean sounding!

--Josh

 

I'll get a better sound clip. This clip doesn't do it justice

 

Awsome Sound!

 

Sounds a bit too loud for my tastes...but....

I like it! Do you feel any HP increases??

 

Butt Dyno says yes, but that all depends on what you've eaten that day LOL.

I've already got my baseline dyno run. After the Crawford Headers, Plenum and TS ECU flash, I'll re-dyno and see what was gained. The only time it gets loud inside is if you're in too low a gear a try to pull through 2k RPM slowly. Then it gets a low roaring howl...I really don't know how to describe it other than that. Once again, I'll have some better vids done in Nashville and LA and post them as they get done. BTW...no Y-Pipe...I used a 2 1/2" X-Pipe to help keep the torque up about halfway down the exhaust (sits right under that black crossbrace)