SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD

I took this intake off of a 2006 Enthusiast I recently purchased. Sounds great, and I could notice the difference when I took it off. Unfortunately, it's not allowed in the autocross class I run in. It was installed as a short ram intake, but the extra piping is also included to install as a cold air intake.

I still have the original installation instructions. I reviewed the parts list, and this kit appears to be missing 1 vibra-mount (little rubber bushing installed where the intake bolts in to prevent rattling), 4 M6 x M16 bolts (I believe these are what's used to attach to the OEM MAF housing, in which case you can just reuse the factory bolts), and 1 intake manifold heat shield (referenced in the parts list, but not shown anywhere else in installation instructions).

This is an oiled filter, and it definitely needs a cleaning. It's also bent, but still useable. If it was me, I'd replace with a new Injen dry filter.

Compare to SP1986P, which is basically the same intake except this one utilizes the OE MAF sensor housing. I think this is a deal at $80 shipped OBO.

 

I'll take it, just tell me who to pay.

Thanks

 

PM Sent, Thanks

 

SOLD