Jacked my car up @ the wrong place, now there's a huge HUMP!
#22
I know it's an old post but...
I know this is a very old thread, but I was wondering/ hoping someone can help me out
i have jacked my car up at the wrong point (on advice from someone else the original CORRECT point was wrong and to use this place)
I was told to use the part beside the wheel arch. Rear drivers side.
Now I have a massive indent in the plastic of my wheel arch and I think the exhaust pipe (or at least something connected to it) has been moved up.
It rattles like a b**** at the rear end now after I've been for a drive.
Any advice would be greatly appreciated thanks...
i have jacked my car up at the wrong point (on advice from someone else the original CORRECT point was wrong and to use this place)
I was told to use the part beside the wheel arch. Rear drivers side.
Now I have a massive indent in the plastic of my wheel arch and I think the exhaust pipe (or at least something connected to it) has been moved up.
It rattles like a b**** at the rear end now after I've been for a drive.
Any advice would be greatly appreciated thanks...
#23
New Member
How's your comprehensive insurance coverage?
Here are the correct jack points on an 08 350z. (Disclaimer: I'm not going to verify that these are the same jack points for your car since you didn't include your vehicle's year in your description):
http://www.nicoclub.com/manuals/350Z...oadster/GI.pdf - Look at Page 37.
Here are the correct jack points on an 08 350z. (Disclaimer: I'm not going to verify that these are the same jack points for your car since you didn't include your vehicle's year in your description):
http://www.nicoclub.com/manuals/350Z...oadster/GI.pdf - Look at Page 37.
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
06-19-2022 06:30 PM
BobC-Z
Upcoming Events
1
09-18-2015 01:57 PM