I recently took apart my intake manifold and replaced my throttle body, at the time i didnt have a torque wrench and so i tightend it with my hand but i didnt put alot of force on it because i know it had torque specs. Can someone please tell me the torque specs for the 6 bolts in the middle and the outer specs. I have no engine mods at all.
-will

 

One of the best sources around is the Motordyne Installation manual for their plenums. It has torque specs and "how to" instructions for those without a torque wrench.

http://www.motordyneengineering.com/...pID=9&CDpath=0

 

Thanks you very much dave!!! This helped alot!!! But 1 last question. Is the torque spec the same if i dont have a plenum spacer installed.

 

yes still the same. 100inch pounds, done in increments