Post your Wings & Things!! SBC represent!
Reviving this thread because I have a question. I'd like to join the SBC but not for 1,500 bucks. I was thinking about getting a Nismo v2 replica in all carbon fiber for 500 or I could get a APR GTC 200 wing for 750. What's the biggest difference between the APR 300 and 200? Should I get the Nismo or APR? Thanks.
So proud of my fellow SBC members!!
Muzzy!! do you have the measurements of the distance between the posts you want to mount to the beam? that will give you a great idea of which airfoil to choose from..
Aeromotions i bet can give you a generic flat deck and mount the pedestal holders anywhere you want (same goes for APR)
also don't forget the lateral support rod that BenSpora used for their GTR wing to prevent side to side vibrations between the pedestals.....
Muzzy!! do you have the measurements of the distance between the posts you want to mount to the beam? that will give you a great idea of which airfoil to choose from..
Aeromotions i bet can give you a generic flat deck and mount the pedestal holders anywhere you want (same goes for APR)
also don't forget the lateral support rod that BenSpora used for their GTR wing to prevent side to side vibrations between the pedestals.....
The stands are already made. I just need a wing now. Need more wing options. Any suggestions out there. I need it 66+ inches and mounts 24-30
I do have the stabalizing bar also
^^^Muzzy, those will fit the Type 8 Voltex? I'm pretty interested in that case. I have one with stands sitting in the box that I haven't installed yet, because I was going to have Freed Engineering in Crofton, Maryland make me some stands.
What are yours made out of, etc, etc? Do you know what height it will put the actual wing at?
What are yours made out of, etc, etc? Do you know what height it will put the actual wing at?
^^^Muzzy, those will fit the Type 8 Voltex? I'm pretty interested in that case. I have one with stands sitting in the box that I haven't installed yet, because I was going to have Freed Engineering in Crofton, Maryland make me some stands.
What are yours made out of, etc, etc? Do you know what height it will put the actual wing at?
What are yours made out of, etc, etc? Do you know what height it will put the actual wing at?
but you could mount them 6" lower under the turn signal lights and then do whatever wing you want. The height is as of now designed to be a little lower then the roof line. Im still in R&D phase.
I will be selling these mounts once I finalize bolt holes and everything. I will offer CS plate and aluminum. right now I'm looking at $250 for steel, and $700 for aluminum. Will debute in June. keep up to date on instagram @muzzyyousefi
Last edited by MUZZY; Feb 22, 2013 at 09:35 AM.
Muzzy been following you on I.G. too. Im digging that wing!
I was wondering how it will actually be mounted? I thought it would go bolted on to the rear crash beam, but from the looks of your concept sketches it sits higher then that.
I was wondering how it will actually be mounted? I thought it would go bolted on to the rear crash beam, but from the looks of your concept sketches it sits higher then that.
There will be a bracket that will mount on top of the crash bar. And the wing will be bolted to it. Still in R&D. Once I finalize, it will be on IG
can't wait to see it finished in a few months 
