Stillen, Greddy, and leather added
#23
Registered User
Thread Starter
iTrader: (3)
Join Date: Mar 2008
Location: santa rosa, TX/Kuwait
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
I do not like the splitter. Looks to aggressive for the rest of the car. Black wheels might look better (to me). Not a fan of the single exhausts either. I dunno doesn't seem to flow. Once your finished I'm sure it will look great though. (OP did say negative comments are welcomed before I get bashed for voicing my opinion) Constructive criticism can always be helpful.
What size/offset RPF1's did you go with? I've been tossing around the idea of getting a square 10.5 setup just for fun.
#24
Registered User
Thread Starter
iTrader: (3)
Join Date: Mar 2008
Location: santa rosa, TX/Kuwait
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
Actually, they are not connected yet, there is diy on how to wire the heat and power in the DIY section. But to bolt the seat down, we had to run the power from the other car because we were using the factory connections.
#25
Registered User
Thread Starter
iTrader: (3)
Join Date: Mar 2008
Location: santa rosa, TX/Kuwait
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
Thank You
To everybody else, thank you for the nice comments. Because of this site and all of you, I did my car right and hopefully make it better in the future.
Thread
Thread Starter
Forum
Replies
Last Post