Nice looking Z!

 

braved the cold washing her, but look at that shine

 

That meaty rear tire/wheel combo is sexy AF, Manny. What's the specs? I bet that thing grips!

 

^ Also curious on those specs. That might be my favorite Z setup I've seen to date. Very clean, very well done.

 

I have yet to driven my Z in these new tires, so I have no idea if they will grip. The wheels are Varrstoens in 18x10.5 +22 and the Mickey Thompson ET street is 305/35/18

* I Need Hood Pins Now!*

 

Let us know how they do!

Ive tried to decide between 3 different MTs and no clue which will grip the best.

 

Dang, that's a 10.5... I may have to sell my wheels and change up for something a bit beefier ;p

 

Hey guys this is my greddy TT 2003 350z ... Im new here ... Never registered for a forum before :P

 

Sweet, welcome aboard!

 

 

Welcome!

 

Good luck with the hood pins. I have a basic set but what a royal ***** it was trying to get those holes drilled straight...

Not to mention the cutting holes in the precious...

 

I've got to do this, thanks for the confidence booster lol

 

It appears that El Nino may actually be taking shape here in NorCal.



End of drought? Won't know until snowpack is measured later this spring. But from the looks of the reservoirs viewed this past weekend, a good sign as much of the dried vegetation that has been on the "banks" of same are now under water.

 

Looks like my rain dance worked.

 

Thankk youuu

 

1000hp!?
On a 350z block? ... Ive been trying to break 700hp with my 20g greddy twin turbo kit without blowing the motor ... Any advice ? ... Im running manley rods and mahle pistons along with l19's studs ... Ported heads as well along with a more than capable fuel system and haltech standalone ecu ... People say i should run a darton sleeved block ... But here were i live (beirut lebanon ) ... There are no CNC machines here to use ... Last time i install darton sleeves they "sunk"

 

dboy is right. Hood pins may have been the only install where I cried the entire way through

 

MM, are you going to be doing the roll racing or Drag racing, or mexico racing?

I will be at TX2K this year, I will probably see you out there, this time I could meet you and not just your car

 

BC or carillo rods, CP or wiseco pistons, there is a company doing closed deck blocks in the states now, that or sleeves, fuel is going to be the bigger issue, need a dual or triple pump made, the greddy kit i think the turbos are only good for 900hp. L19s are good, ported heads are good, id run cams, personally lookign at tomei 280 exhaust and intake for 8000rpm.

im only starting the build. Players like MM08 are 900whp and right there at it.