My "Clean" Nitrous Install
Did this last summer and don't think I ever shared pics, so here they are:
It's just your typical Wet Nitrous setup that I added a few extra parts to to spice it up a little.
If you look at this pic, just to the right of the throttle body there are two AN Bulkhead fittings. This is where my fuel line from the fuel rail and nitrous line from the tank go into the compartment that has the brake booster under it. My solenoids are hidden and mounted under there.

The fuel and nitrous lines exit through a factory grommet and go to the nozzle here:

In the trunk I added an NOS Billet Dual bottle Bracket and a second bottle, just for fun.

I've also got a TurboXS UTEC to aid in tuning and a Walbro 255lph pump in tank to supply any additional required fuel.
I've got a Vortech kit sitting in my closet waiting to go in this spring, so the nitrous kit is probably coming out.
It's just your typical Wet Nitrous setup that I added a few extra parts to to spice it up a little.
If you look at this pic, just to the right of the throttle body there are two AN Bulkhead fittings. This is where my fuel line from the fuel rail and nitrous line from the tank go into the compartment that has the brake booster under it. My solenoids are hidden and mounted under there.

The fuel and nitrous lines exit through a factory grommet and go to the nozzle here:

In the trunk I added an NOS Billet Dual bottle Bracket and a second bottle, just for fun.

I've also got a TurboXS UTEC to aid in tuning and a Walbro 255lph pump in tank to supply any additional required fuel.
I've got a Vortech kit sitting in my closet waiting to go in this spring, so the nitrous kit is probably coming out.
Nice location of the solenoids and the fogger. 
BTW, keep the nitrous and spray on top of the SC. Instant power of nitrous at low RPMs + top end power of the SC = win.

BTW, keep the nitrous and spray on top of the SC. Instant power of nitrous at low RPMs + top end power of the SC = win.
Any chance you can post a pic of your solenoids? I've been trying to move mine to the same location but theres not a lot of room in there with all the hard lines. Haven't found a good way to mount the solenoids.
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
May 16, 2016 10:42 PM





