When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
scott, how hard was it to install the nismo shift ****?
It's really simple, took me roughly 2 minutes. Just unscrew your ****. Once you do that undo the center piece of the GT shift ****. Once you do that you should have three pieces (Inside that screws on the shifter, the ****, and the screw from the top). Screw down the inside piece as tight as you can, then place the **** back over it. Once you do that, position the **** whatever way you want the NISMO etching to face and then put the screw back in the top. Make sure you tighten the screw as much as possible because the **** will spin a bit if you leave it loose.
Best thing to do is use lock-tight or whatever once you take the original **** off the shifter. I also took Chris's advice and put rubber bands under my shift boot to keep it directly under my ****. If you want to completely avoid what I told you to do, just unscrew your old one, and screw on the new one. The NISMO etching will probably just be facing a weird angle.
