okay, when fulled closed position or full backed down position, are they at LEAST the oem dimension from center of bolt to center of bolt........??

 

Sorry, I don't have my OEM links to compare. You might PM Adam @ Z1 Performance, he sells them

 

i measure about 3.75 inch, is that about what they can go down to? or less preferably?

 

You can adjust the PG endlinks to be the same as oem

 

Okay, Whats the range..........how much below and how much above........whats the range 3.xx inch to 4.xx inch???


-J

 

i'm not sure what the range is, but you can go longer and shorter than stock

 

^ cool...thanks.

if anyone has them off? can you measure what they stop down too? (shortest measurement) and what they extend to with decent amount of thread still engaged for strength, at least half the threads still inside.

-J

 

anyone with the powergrids finding out that the front are too long?
if you put the with hotchkis sway bars stiffest setting? 4th hole?

thanks

 

There is no reason you should even be using the 4th hole on your hotchkis front bar - it puts any endlink at simply too steep of an angle for me to consider it safe.

Stick to Hotchkis's recommended settings front and rear, and follow the instructions for setting length that are included with the endlinks and you'll end up in good shape.

Any shop that has scales will know automatically what to do with the endlink length to set preload as part of doing a cornerbalance.

 

once again, can anyone measure them for me>? as stated previously?

or

take a pic with the front power grids next to a front oem endlink..........im thinking they wont adjust down to oem length?

-J

 

I just ordered some powergrids.

What type of shop is likely to have the knowledge to install these properly? I have Hotchkis v2 sways on a stock suspension.

 

Speedware is in Redmond, a lil pricey, i have SPL endlinks sitting in my living room and will probably take them to speedware as well.

goodluck!