i just picked up a used set of tein s techs...and i was wondering what the going rate for installation is? any input will be greatly appreciated. thanks

 

i wouldnt pay more than an hour worth of labor.

 

just do them yourself... The back springs should take no more than 10 minutes a side, and i think it was one bolt on the bottom, and the two inside the trunk. The front is the work, but it shouldn't take that long. Just beware of the dual dampening shocks. I have those exact same springs, and it was actually a lot easier to put those on than it was for me with a bunch of hondas i dropped.

If you're looking to take them in, it'll probably cost around $120.

 

shoots thanks for the advice...ya im not much of a do-it-yourself guy lol. i wish i was...

 

if you end up doing it lmk. i'll give you a hand. I have my hotchkis springs I was going to install, but am very lazy. Have all the necessary equip to do it (i.e. spring compressor, air tools, etc.).

 

shoots. im down for that. ill pm you my number

 

if you guys need help i'm always down to help lmk

 

uh oh.... I guess i just found my test pipe solution

I'll help u do your springs. Then i can ask for help with my test pipes! hehe...

 

Aww damn should've checked this earlier. I just finished taking off my exhaust so i can sell it. Thought it would take a while but only took my friend and I 40 min.

 

just bring um over here

 

If you need spring compressors for the front I have a pair. Let me know if you need them.

 

Or if you guys want, we can have a quick install day at my house. Crap part is, I'm in waipio gentry. I wasn't planning on installing my springs until I got my rims but I wanted to help out with the drop. That way I learn from you guys since this is my first time doing springs on a 350z.

 

if you guys need i got an air compressor. i just have tools for it. and i got a **** load of tools laying around after my last round of mods. so lmk too and we can do an install day if you guys want. haha i wanna do it at my house though. i got lots of pretty posters thats why

 

Its fairly easy to do on stands. The trick for the fronts is after undoing the 3 nuts up top, its easier to pop the nut off the A-arms and let the whole thing swing out. saves alot of time.