What have you done for your Z today?
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
Registered User
Join Date: Aug 2016
Location: Pueblo West, Colorado
Posts: 439
Likes: 0
Received 31 Likes
on
27 Posts
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
6 inch cawk is my fave!
iTrader: (3)
I donno I was pretty excited when I rid my life of these.
But now I find myself hoarding other parts that will most likely never get used again...
Like my extra driveshaft, 2 spare differentials, extra computer, extra set of pedals, etc etc etc
On a side note im hoping to make a scrap metal run today if I can convince myself that I won't ever need the extra sheet metal.
But now I find myself hoarding other parts that will most likely never get used again...
Like my extra driveshaft, 2 spare differentials, extra computer, extra set of pedals, etc etc etc
On a side note im hoping to make a scrap metal run today if I can convince myself that I won't ever need the extra sheet metal.
Registered User
Join Date: Aug 2016
Location: Pueblo West, Colorado
Posts: 439
Likes: 0
Received 31 Likes
on
27 Posts
I donno I was pretty excited when I rid my life of these.
But now I find myself hoarding other parts that will most likely never get used again...
Like my extra driveshaft, 2 spare differentials, extra computer, extra set of pedals, etc etc etc
On a side note im hoping to make a scrap metal run today if I can convince myself that I won't ever need the extra sheet metal.
But now I find myself hoarding other parts that will most likely never get used again...
Like my extra driveshaft, 2 spare differentials, extra computer, extra set of pedals, etc etc etc
On a side note im hoping to make a scrap metal run today if I can convince myself that I won't ever need the extra sheet metal.
New Member
Spray painted*
6 inch cawk is my fave!
iTrader: (3)
3rd blade snapped and I gave up for the day... Truck was full anyways... Here are some interesting not frequently available pictures.
Behind door cross section
Reinforced area for coil spring
Progress
Behind door cross section
Reinforced area for coil spring
Progress
New Member
EBC kit rotor and pads all around
Just completed installing these!
Couldn't have finished this project without autozones 3 jaw puller. Makes popping off rotors ratchet.
Just have to torque down the spacers to specifications and bolt on wheels.
This job has taken me on and off two days.
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
Mount 'em up, cowboy!!
Also gave away a set of sticky tahrs.
Also gave away a set of sticky tahrs.
New Member
iTrader: (2)
What I did today~
SPC toe bolts installed
SPC rear camber arms installed
Circuit Sports lock out kit installed
Removed slight surface rust on rear top hats and rear shock towers
Painted part of the exhaust to hide some ugly welds
I need to install kinetix control arms and whiteline bushings in the front to finish my suspension and then i'm ready for an alignment to get rid of the stupid amount of camber I currently have.
SPC toe bolts installed
SPC rear camber arms installed
Circuit Sports lock out kit installed
Removed slight surface rust on rear top hats and rear shock towers
Painted part of the exhaust to hide some ugly welds
I need to install kinetix control arms and whiteline bushings in the front to finish my suspension and then i'm ready for an alignment to get rid of the stupid amount of camber I currently have.