Cheap, lightweight wheels: RPF1 killer?
#23
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
#25
New Member
Thread Starter
Hypergrams
18x10.5 +25 square
275/35 Federal 595RS-RR square (easily as wide as typical 285)
-2 deg front
-1.5 rear
dropped 1" front, .25" rear
sitting nose up on steep driveway, so front/rear ride height is little skewed.
18x10.5 +25 square
275/35 Federal 595RS-RR square (easily as wide as typical 285)
-2 deg front
-1.5 rear
dropped 1" front, .25" rear
sitting nose up on steep driveway, so front/rear ride height is little skewed.
The following users liked this post:
guitman32 (07-07-2018)
#26
Registered User
Ugh, that would be the setup I'd get too. I thought I decided I was happy with my stock 5 spokes but that setup looks so good.
#28
350Z-holic
iTrader: (13)
fun times ...
Last edited by bealljk; 07-06-2018 at 03:10 PM.
#31
General & Tech Moderator
MY350Z.COM
MY350Z.COM
#32
350Z-holic
iTrader: (13)
The following users liked this post:
jhc (07-08-2018)
#34
New Member
iTrader: (13)
Little known- if you notice the DST logo (Dynamic Spinning Tech) on the wheel, it is also part of Advanti Racing. Advanti, Advan, Konig, Enkei, OZ, several other brands all subcontract YHI International manufacturing for many (but not all) of their wheels. Sometimes you will see cross logos across different brands.
http://www.yhigroup.com/
http://www.yhigroup.com/
Thread
Thread Starter
Forum
Replies
Last Post
TopSpeedAutoSport
Wheels & Tires
11
02-03-2011 04:54 PM
TopSpeedAutoSport
Wheels & Tires
11
02-03-2011 04:54 PM
RavSpec
Wheels & Tires
7
04-08-2010 08:57 PM