Older version of Osiris User Guide??
Thread Starter
Registered User
Joined: Oct 2018
Posts: 5
Likes: 0
From: AB
Older version of Osiris User Guide??
As per title, I am hoping someone can help me out or let me know where to find an older uprev Osiris User Guide v2, or if you have one kicking around in their laptop, maybe you can upload it?
The reason is that It seems the current version of the user guide in uprev website is missing quite a bit of information the older user guide contains. I have been reading the sticky threads uprev tuning 101, a lot of post refers to a V2 guide that doesn't exist anymore. Couple examples below of the stuff missing in current user guide.
post #54 talks about intake temp calibration, not found in current guide
"Page 18 of Osiris manual on the Uprev website. Number 11.9 halfway down the page.
11.9 Intake Temp Calibration – Intake temp can be adjusted based off of sensor voltage."
post #84
"The 100% WOT is a checkbox option inside of Osiris, you don't need to change the throttle voltage table. You would only do that if you were trying to calibrate your throttle pedal response to a personal preference (like a different response curve than stock).
Check the top of page 14 of the Osiris manual at: http://www.uprev.com/documentation/Osiris User Guide V2.pdf
for each map, you can choose whether to set Electronic Throttle Control as "Stock" or "UpRev Tuned". This is what eliminates the 80% throttle limitation and get you 100% throttle from a dead stop."
The reason is that It seems the current version of the user guide in uprev website is missing quite a bit of information the older user guide contains. I have been reading the sticky threads uprev tuning 101, a lot of post refers to a V2 guide that doesn't exist anymore. Couple examples below of the stuff missing in current user guide.
post #54 talks about intake temp calibration, not found in current guide
"Page 18 of Osiris manual on the Uprev website. Number 11.9 halfway down the page.
11.9 Intake Temp Calibration – Intake temp can be adjusted based off of sensor voltage."
post #84
"The 100% WOT is a checkbox option inside of Osiris, you don't need to change the throttle voltage table. You would only do that if you were trying to calibrate your throttle pedal response to a personal preference (like a different response curve than stock).
Check the top of page 14 of the Osiris manual at: http://www.uprev.com/documentation/Osiris User Guide V2.pdf
for each map, you can choose whether to set Electronic Throttle Control as "Stock" or "UpRev Tuned". This is what eliminates the 80% throttle limitation and get you 100% throttle from a dead stop."
Thread Starter
Registered User
Joined: Oct 2018
Posts: 5
Likes: 0
From: AB
Really? This is the first i am hearing this. Could you provide more detail on that? I thought uprev really improved over the years. I got the tuner version and I am trying to tune my 2006 G35 and any additional information will help.
Thread
Thread Starter
Forum
Replies
Last Post
R/T Tuning
Engine
3
Jun 28, 2013 07:29 AM
bboysteele
South West
2
May 5, 2008 12:48 PM