I have AZA Z1 wheels which are hubcentric and just had wheel spacers made by Performance Nissan which are not hubcentric.

Although I have the plastic hubcentric rings for my wheels, the problem is that they fit the inside of my wheels and are flush with the inside surface of my wheels, so they don't help center the wheel with the wheel spacers (they are meant to fit the wheel snug around the car hub, but the hub is now covered by the wheel spacer).

What it seem that I need are hubcentric rings that are long enough to fit both inside the wheel bore AND inside the wheel spacer bore at the same time.

Jason at Performance Nissan says he can manufacture those for me, but before going that route, I was wondering if anyone knows where else I can find some or if anyone has a similar setup themselves.

My specs are as follows:
AZA Z1 wheel bore = 73.1
Front spacers = 12mm
Rear spacers = 13mm

Hope this all made sense Any help is appreciated.

 

give this place a try http://www.wheeladapter.com

 

Yup try http://www.wheeladapter.com.

Fred did mines and they r great.