Fitting front wheels
Thread Starter
Registered User
iTrader: (3)
Joined: Jul 2007
Posts: 32
Likes: 0
From: Queensland, Australia
Fitting front wheels
Just got a quick question regarding the fitting of front aftermarket wheels. My TE37 will not fit on the front due to that little rod/bolt between the 2 wheel studs. Is it safe to remove this so my wheels will fit? What exactly is it there for?
Also, is using stock lugnuts on TE37 fine? I will be getting RAYS lugnuts but in the meantime I'll use the stock ones if they are fine.
Thanks
Also, is using stock lugnuts on TE37 fine? I will be getting RAYS lugnuts but in the meantime I'll use the stock ones if they are fine.
Thanks
Thread Starter
Registered User
iTrader: (3)
Joined: Jul 2007
Posts: 32
Likes: 0
From: Queensland, Australia
Thanks for the reply. I'm not that stupid that I would put the rear on the front, I just wasn't sure what it was for. Thanks again 
And what about the stock lugnuts? Will they be fine until I get RAYS ones?
And what about the stock lugnuts? Will they be fine until I get RAYS ones?
Last edited by dreamstation; Jan 26, 2008 at 02:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post
350Z Project X
Suspension
9
Oct 10, 2015 09:23 AM