Bronze TE37 18" +12F/+15 rear: ballers welcome
05-16-2008 | 10:37 AM
#21
Originally Posted by nlzmo400r
very good lookin car man, nice color combo and TE's are classic, they'll look good on damn near anything. Just be aware that when you add 2 more degrees of negative camber up front, it will sink that wheel. Just go minor with the camber and it'll keep it lookin flush. You may even want to space the rear as my rpf1's (18x10.5 +15) look SOO much better with a 15mm spacer back there. And I run apprx. -3.o of rear camber.
05-16-2008 | 01:15 PM
#22
Originally Posted by guitman32
I do think I would have gone +15 front (a tad too much "poke" for my taste).
for the 18x9.5 TE37s, Volks offer +12, +22, +35
the +22 wont have as much concavity as the +12.
05-16-2008 | 05:28 PM
#25
Originally Posted by punch10
Do you pics of this +0 offset setup?
05-16-2008 | 09:53 PM
#26
Originally Posted by Andy@Performance
OMG Tyler, that is freaking HOT! I think you need a little bit more of a drop though. I should have given you some "replacement" stickers for your car, lol!
I'm going to drive with this suspension for a bit, but I'm 90% sure I'll be hitting you up about some coil-overs.
05-17-2008 | 12:40 AM
#29
Originally Posted by Chebosto
for the 18x9.5 TE37s, Volks offer +12, +22, +35
the +22 wont have as much concavity as the +12.
the +22 wont have as much concavity as the +12.
Great point, mixed up the two...have been looking at so many square 10.5" setups
05-17-2008 | 11:04 PM
#35
Originally Posted by nlzmo400r
a friends car, but same setup (265/35 falken azenis) 18x10.5 f/r +15offset up front and 0 in the back (via 15mm spacer)
I bought gf210 thinking 1.2" was enough with 18" riding on 35 series...
I was wrong.
05-17-2008 | 11:44 PM
#36
OP very nice!
heres mine
Eibach Sportlines (1.2" drop)
Hotchkis Sway Bars
TE37
18x9.5 +22 Front
18x10.5 +22 Rear
Falken Azenis RT 615
245/40/18 Front
275/35/18 Rear
Stoptech Front 13inch Kit (ST40/332mm rotors)/Hawk HP+
Stock 04 Rear Calipers: Powerslot rotors/stoptech lines/Hawk HP+
Motul Fluid
Nismo 50mm hub bolts(extended)
Muteki open end lug nuts (black)
Pics: (Excuse the guy in the background)
heres mine
Eibach Sportlines (1.2" drop)
Hotchkis Sway Bars
TE37
18x9.5 +22 Front
18x10.5 +22 Rear
Falken Azenis RT 615
245/40/18 Front
275/35/18 Rear
Stoptech Front 13inch Kit (ST40/332mm rotors)/Hawk HP+
Stock 04 Rear Calipers: Powerslot rotors/stoptech lines/Hawk HP+
Motul Fluid
Nismo 50mm hub bolts(extended)
Muteki open end lug nuts (black)
Pics: (Excuse the guy in the background)
05-19-2008 | 09:41 PM
#37
Very nice. I haven't even had my car out yet as I managed to destroy two of my front passenger studs on Thursday (just rolled it out for pictures). Picked up and installed the new ones today and adjusted one side on the front for camber. Think I need to add a bit more but I was tired.
Thread
Thread Starter
Forum
Replies
Last Post
ars88
Zs & Gs For Sale
18
04-04-2016 08:52 AM
