Hi all,

I intend to buy this bbk set:
Stoptech 6 Piston Front Kit (ST-60) 2PC 355X32MM
Stoptech 4 Piston Rear Kit (ST-45) 2PC 355X32MM

Can i check if they are able to clear ROTA 18x9.5 F / 18x10 R offset +25?

Anyone with same set up has this bbk?

Thanks.

 

best bet is take the caliper clearance diagrams off Stoptech's website and send them to Rota to verify clearance.

 

I sincerely doubt it... check the backspacing info from the site but I have 19x9.5/10 +12 Volk TE37's and my 6-pot Endless' hardly clear those. I had Akebono's on BBS LM's 18x9.0/10 and they cleared by maybe a 1mm. Blck350z had 6-pot D2's on +22 TE37's and he had to run a spacer. Good luck

 

Like Z1 Performance says:

Find a template on the internets.
Paste the template to a piece of cardboard.
Cut out template.
Fit template inside wheel.

 

Hope your rotas don't brake

 

Rota what? They only make like 50 different wheels, you need to post the actual wheel you are wanting to use.

 

oh i c wat u did there

 

Always happy to help. If you have other questions please do not hesitate to waste my time.

 

Damn Dave your on fire with reviving these older threads.

 

I hope they brake, but I wouldn't want them to break.

OP: If you haven't already bought the wheels, you might want to take a look at Enkei wheels. Enkei makes very affordable wheels, and their quality is quite a bit better than Rota.