quickdiversion

I will start off with.

I have read the removal procedure twice now for removing the forward and aft bellhousing a from the adaptor plate and that all makes sense to me.

My only question is for those that have done this, have you had any issues with items detaching from the center section that holds the guts when pulling the forward bell housing off? Any kind of retainers, spacing material, or grommets to keep an eye out for?

canadarob

iTrader: (1)

From what I remember Nissan used liquid gasket to seal those sections.
Just use a flathead and pry apart.
Nothing that I remember being an issue really. Keep and eye on the shifter fork shafts as one or two separate from roller bearings in the front of the case.




Rob

quickdiversion

Cool. This is the info I was looking for.
I have never opened a trans before and nothing is mentioned in the manual or shown in pictures.

Thank you.

travlee

iTrader: (8)

why are you opening it up?

quickdiversion

Having the bellhousing milled off for an adaptor plate.

quickdiversion

Ha the previous post didn't show up till I tried to repost....