When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Installed heavy duty hatch struts! So far they're great! True test will be when I dig the Z out from under all the snow and see if the hatch stays open!
Got extra heavy duty custom Headlight/Taillight tints along with a matte black roof overlay. Painted the calibers flat black and added some 25mm spacer all around.
new car it is.
Went to a fancy restaurant with my lover, and had a nice dinner. The next day, I looked at my rear right wheel, and noticed it was curbed about half an inch. FU*K!
Went to a fancy restaurant with my lover, and had a nice dinner. The next day, I looked at my rear right wheel, and noticed it was curbed about half an inch. FU*K!
refilled the air in all tires after the idiots who changed my oil didn't screw on the caps tight enough. they were all loose and 1 actually fell off, so i'm only rolling with 3 valve caps until i go get a new set tomorrow.
Did research on some decent fitting rims so that I can finally put my BBK on... And ordered headers... And a cat-back.... and intake... and short throw shifter... and plenum spacer... Hmm, I should probably dig her out of the snow too LOL, damn blizzard
Installed heavy duty hatch struts! So far they're great! True test will be when I dig the Z out from under all the snow and see if the hatch stays open!
Where'd you get them (truly sorry if this is on another thread, 3am, kinda lazy). I'm tired of getting a concussion every time I need to get something out of the back. Cold weather FTW, not.
as of today meaning right this second. I have my Z at my house in my Nice tent all waxed up and shining. Only due to living in NJ it has just snowed like a mother and even if i wanted to i would not be able to driver her ANYWHERE!!!
i heard a noise coming from the passenger wheels. so i took the wheel out and found out that one of the bolt on the upper control arm was losing so i have retighten. and so i did the rest and check everything and retighten on four corners.
