A better solution to stock wheel bearings
#1
Registered User
Thread Starter
Join Date: Dec 2012
Location: Las Vegas, Nv
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
A better solution to stock wheel bearings
So I Normally do auto x in my nismo 350 with a set of dot r comps, and I have blown out my first wheel bearing. I went ahead and replaced with just a standard bearing but I swear I remember reading that some of the track guys on here are using bearings out of a nissan Suv, I believe I saw it mentioned in the 50+ pg thread for the intro of spec z but I'm not sure and a few days of searching hasn't yielded any solid leads can any of you heavy track users give me a hand in finding a better solution as I would prefer to get the heavier duty bearings in because I'm about to start going to any near local track days and time attacks.
thank you guys.
thank you guys.
#2
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Nissan Morano FWD rear bearings up front, but it requires some work from what I understand. I have yet to grab a set to play with.
Sounds like I may have another Z in Vegas to play with at the track when I get home.
Sounds like I may have another Z in Vegas to play with at the track when I get home.
#3
Registered User
Thread Starter
Join Date: Dec 2012
Location: Las Vegas, Nv
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
absolutely it would be fun instead of having to chase Kam in his s2k. the auto x is getting z heavy too with 3 350zs at the last one and we were missing one regular... also does that mean the murano front bearings might work on the rears?
Last edited by Enemy; 05-07-2014 at 04:37 AM.
#4
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Chasing Kam is fun, we usually push each other pretty hard. It's the rear wheel bearing of a FWD that has been used on the front of a Z. Fontana Nissan did it on their Z , and I have heard it is and is not a direct fit.
Thread
Thread Starter
Forum
Replies
Last Post
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM