Notices
2003-2009 Nissan 350Z

350z wont start and has no power

Thread Tools
 
Search this Thread
 
Old 11-24-2022, 09:38 AM
  #1  
danielsvq
Registered User
Thread Starter
 
danielsvq's Avatar
 
Join Date: Nov 2022
Location: florida
Posts: 1
Received 0 Likes on 0 Posts
Default 350z wont start and has no power

i was coming home one day and i accidentally stalled out in the driveway so i tried starting her back up no luck but it turned over…

i did it once more with no luck but this time there was no turn over and power went completely out but the brake lights, gas cap button,security light, and the ignition ringtone works.


i thought maybe its the battery, nope battery is all good along with the fuses, even the terminals are okay what is the problem im having could it be immobilized? maybe ignition switch?
Old 11-24-2022, 10:06 AM
  #2  
dkmura
General & DIY Moderator
MY350Z.COM
iTrader: (64)
 
dkmura's Avatar
 
Join Date: May 2002
Location: Aurora, Colorado
Posts: 8,418
Received 1,305 Likes on 905 Posts
Default

Welcome, but it could be something much simpler. Be sure to check your battery connections, not only at the terminals, but also at the ground side to make sure there's a solid connection there. Old-timers like me like to use a 10mm wrench, stiff wire brush and tube of dielectric grease to ensure the connections are clean and tight. If this doesn't work you can go on to more complicated fixes, but it's amazing how many times this simple maintenance chore is overlooked.
The following users liked this post:
danielsvq (11-24-2022)
Old 11-25-2022, 06:53 AM
  #3  
bre240z
New Member
 
bre240z's Avatar
 
Join Date: Dec 2021
Location: La Puente CA
Posts: 296
Received 79 Likes on 64 Posts
Default

how do you know the battery is good? How old is the battery? Like mentioned above I would disconnect terminals and give them a good clean.Good luck
Old 11-26-2022, 05:07 PM
  #4  
dboyzalter
6 inch cawk is my fave!
iTrader: (3)
 
dboyzalter's Avatar
 
Join Date: Apr 2015
Location: Mass
Posts: 6,557
Received 972 Likes on 759 Posts
Default

Probably doesn't think the clutch is pushed down because the little plunger is stuck.
Old 12-01-2022, 12:53 PM
  #5  
icer5160
New Member
iTrader: (4)
 
icer5160's Avatar
 
Join Date: May 2010
Location: Brentwood, CA
Posts: 1,416
Received 441 Likes on 336 Posts
Default

As a test, I would try jumping the starter solenoid relay just to see if that will get the engine turning over, alternatively, you could swap one of the other relays with the starter relay and give it a try. If swapping or jumping works, then you have a bad relay (P/N ACM33221, gray relay in the engine IPDM). If this doesn't solve the issue, then either the clutch pedal switch has failed as dboyz mentioned (very possible), or you may have an issue with the antitheft system (doubtful), or possibly a wiring fault/short (also doubtful).
Good Luck!
-Icer
Old 12-06-2022, 12:00 PM
  #6  
icer5160
New Member
iTrader: (4)
 
icer5160's Avatar
 
Join Date: May 2010
Location: Brentwood, CA
Posts: 1,416
Received 441 Likes on 336 Posts
Default

OP, curious if you have any updates on this issue?
-Icer
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Martinezjr4
Maintenance & Repair
12
10-16-2021 09:58 AM
nbelt250
Audio, Video & Electronics (DIY)
0
10-06-2021 09:41 AM
digitaltrance
Maintenance & Repair
6
01-19-2011 12:06 PM
zulator03
Maintenance & Repair
13
07-15-2009 11:08 PM
marques1
Maintenance & Repair
7
07-08-2009 03:37 PM



Quick Reply: 350z wont start and has no power



All times are GMT -8. The time now is 07:25 AM.