So my obd2 won’t read
#1
Registered User
Thread Starter
Join Date: Apr 2023
Location: Bakersfield
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://my350z.com/forum/images/icons/icon1.gif)
I went to plug in my obd2 and the scanner jus loads forever and does nothing I tried the same scanner on another car and it worked so ik it’s not the scanner any ideas?
#3
New Member
iTrader: (14)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Take a look at the OBD2 connector and make sure the pins on 6 and 14 are not spread and are fully seated in the connector. If your scanner is powering up, chances are you have power at pin 16 and ground on pins 4 and 5, however its always good to check.
Are you trying to communicate with the key on in accessory, or with the engine running? Try both
Are you trying to communicate with the key on in accessory, or with the engine running? Try both
Thread
Thread Starter
Forum
Replies
Last Post